Removal Procedure
- Remove the engine sight
shield.
- Disconnect the accelerator
cable from the throttle body lever.
- Remove the accelerator
cable from the cable bracket.
- Unclip the accelerator
cable from the engine sight shield mounting bracket.
- Remove the left instrument
panel (IP) insulator.
- Disconnect the accelerator cable retainer (3) from the
accelerator pedal lever (2).
- Squeeze the accelerator cable cover tangs (1) and push
the cable through the dash panel.
- Remove the accelerator cable.
Installation Procedure
- Install the accelerator
cable through the dash panel. Snap the accelerator cable cover tangs (1)
through the dash panel.
- Install the accelerator cable through the slot in the accelerator
pedal lever (2).
- Seat the retainer (3) in the accelerator pedal lever (2).
- Connect the accelerator
cable to the throttle body lever.
- Slide the accelerator
cable into the slot on the accelerator cable bracket. Snap the locking tab
into position.
- Clip the accelerator cable
into the engine sight shield mounting bracket.
- Test for complete throttle
opening and closing range by operating the accelerator pedal. Also inspect
the carpet fit under the accelerator pedal. The throttle should operate
freely without binding between full closed throttle and wide
open throttle (WOT).
- Install the left instrument panel insulator.
- Install the engine sight shield.