GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the front differential carrier shield, if equipped. Refer to Shield Replacement .
  3. Clean the area around the front axle fill plug and the drain plug.
  4. Remove the fill plug.

  5. Object Number: 834237  Size: SH
  6. Remove the drain plug.
  7. Drain the fluid from the front differential carrier assembly.

Installation Procedure


    Object Number: 834237  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the drain plug.
  2. Tighten
    Tighten the drain plug to 33 N·m (24 lb ft).

  3. Fill the differential carrier assembly with axle lubricant. Use the proper fluid. Refer to Approximate Fluid Capacities and Fluid and Lubricant Recommendations in Maintenance and Lubrication.
  4. Install the fill plug.
  5. Tighten
    Tighten the fill plug to 33 N·m (24 lb ft).

  6. Install the front differential carrier shield, if equipped. Refer to Shield Replacement .
  7. Lower the vehicle.