GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
  2. Remove the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.

  3. Object Number: 399638  Size: SH
  4. Remove the horn plunger from the steering column by pressing inward to the stop and rotating horn plunger 90 degrees.

  5. Object Number: 395771  Size: SH
  6. Remove the horn contact plate retaining screws from the steering wheel.
  7. Remove the horn plunger from the steering wheel.

Installation Procedure


    Object Number: 395771  Size: SH
  1. Install the horn plunger to the steering wheel.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the horn contact plate retaining screws to the steering wheel.
  4. Tighten
    Tighten the horn contact plate retaining screws to 5.5 N·m (50 lb in).


    Object Number: 399638  Size: SH
  5. Install the horn plunger to the steering column.
  6. Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
  7. Enable the SIR system. Refer to Enabling the SIR System in SIR.