J 41396 Park Lock Cable Pliers
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury • Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the 3 TORX® screws to 10 N·m (89 lb in).
Important: Lubricate all of the moving parts of the linear shift assembly with synthetic grease.
Tighten
Tighten the 3 TORX® screws to 10 N·m (89 lb in).
Tighten
Tighten the hexagon flange head bolt to 18 N·m (14 lb ft).
Tighten
Tighten the 3 TORX® screws to 6.5 N·m (58 lb in).
Tighten
Tighten the hexagon flange head bolt to 18 N·m (14 lb ft).
12.1. | Place the steering column lock cylinder set into the off position. |
12.2. | Place the shift lever clevis into the park position. |
12.3. | Press the locking tab on the end of the park lock cable assembly (1) into the slot in the lock module assembly. |
13.1. | Put the lock cylinder in the OFF-LOCK position. The shift lever clevis should not be able to shift out of the park position. |
13.2. | Turn the key to the run position and put the shift lever clevis in the neutral position. |
13.3. | With the shift lever clevis in the neutral position the lock cylinder should not be able to go into the OFF-LOCK position. |
13.4. | Put the shift lever clevis into the park position. |
13.5. | Put the lock cylinder in the OFF-LOCK position and then remove the key. |