- In order to adjust the glass height, the sunroof glass must be in the zero (closed) position.
- Loosen the 4 adjustment screws
- Adjust the rear glass panel (1) so that it is flush with the roof panel (3), (0-2.0 mm (0.079 in) above 3).
- Adjust the front glass panel (2) so that it is flush with the roof panel (3), (0-2.0 mm (0.079 in) below 3).
Important: Do not remove the screws from the sunroof mechanism.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten rear screws to 7 N·m (62 lb in).
Tighten
Tighten front screws to 7 N·m (62 lb in).
