For 1990-2009 cars only
Removal Procedure
- Remove the upper garnish molding. Refer to Rear Upper Garnish Molding Replacement .
- Remove the D-Pillar molding.
- Disconnect the electrical connectors.
- Push on the tab (2) in order to remove the switch from the D-Pillar molding.
- Insert a small screwdriver between the tab (1) in order to pry out the switch from the case.
Installation Procedure
- Install the switch into the case by pushing until the tab (1) locks into place.
- Install the switch assembly into the D-Pillar molding.
- Connect the electrical connectors.
- Install the D-Pillar molding to vehicle.
- Install the upper garnish molding to vehicle. Refer to Rear Upper Garnish Molding Replacement .
