Jack and Tool Stowage Replacement Extended Cab

1. Remove the nuts retaining the jack and the bracket.
2. Remove the jack and the bracket from the vehicle.
3. Remove the nut retaining the tool kit.
4. Remove the tool kit from the vehicle.

1. Install the tool kit and the retaining nut.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the jack and the bracket with the retaining nut.

Tighten
Tighten the nuts to 9 N·m (80 lb in).

Jack and Tool Stowage Replacement Regular Cab

1. Remove the nut retaining the tool stowage cover and remove the cover, if equipped.
2. Remove the nuts retaining the jack and the bracket.
3. Remove the jack and the bracket from the vehicle.
4. Remove the nut retaining the tool kit
5. Remove the tool kit from the vehicle.

1. Install the tool kit and the retaining nut.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the jack and the bracket with the retaining nut.

Tighten
Tighten the nuts to 9 N·m (80 lb in).

3. Install the nut retaining the tool stowage cover, if equipped.

Jack and Tool Stowage Replacement Suburban/Yukon XL

1. Remove the storage tray located in left rear of vehicle.
2. Remove the wing nut retaining the tool kit bracket.
3. Turn the adjusting knob on jack assembly counter-clockwise.
4. Remove the jack.

1. Install the jack to vehicle.
2. Turn the adjusting knob on jack assembly clockwise until tight.
3. Install the wing nut retaining the tool kit bracket.
4. Install the storage tray to left rear of vehicle.

Jack and Tool Stowage Replacement Tahoe/Yukon

1. Tilt forward the drivers side rear seat bottom.
2. Turn the wing nut counterclockwise.
3. Remove the tool kit.



4. Open the door on left rear of vehicle below speaker grille.
5. Turn the adjusting knob on jack counterclockwise.
6. Remove the jack from vehicle.

1. Install the tool kit.
2. Turn the wing nut clockwise.
3. Tilt down the back drivers side rear seat bottom.



4. Install the jack to vehicle
5. Turn the adjusting knob clockwise.
6. Close the door in left rear of vehicle below speaker grille.