GM Service Manual Online
For 1990-2009 cars only

Important: Be sure to keep parts in order. Parts must be put back from where they were removed.


    Object Number: 470906  Size: SH
  1. Apply sealer GM P/N United States 12346004, GM P/N Canada 10953480, or equivalent to the valve rocker arm stud-to-cylinder head threads.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the push rod guides and valve rocker arm studs onto the cylinder head.
  4. Tighten
    Tighten the valve rocker arm studs to 50 N·m (37 lb ft).


    Object Number: 470903  Size: SH

    Important: The 8.1 L engine uses different length intake and exhaust valve push rods.

    The exhaust valve push rods (2) are longer than the intake valve push rods (1).

  5. Install the valve push rods.

  6. Object Number: 470899  Size: SH
  7. Coat the valve rocker arm and valve rocker arm ball bearing surfaces with prelube GM P/N United States 1052367, GM P/N Canada 992869, or equivalent.
  8. Install the valve rocker arms, the valve rocker arm balls and the valve rocker arm nuts.
  9. Tighten
    Tighten the valve rocker arm nuts slowly, to 25 N·m (19 lb ft), while guiding the tips of the rocker arms over the tips of the valves.