GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2003 🢒 Yukon XL - 4WD 🢒 Driveline/Axle 🢒 Transfer Case - NVG 246-NP8 🢒 Transfer Case Shift Control Switch Indicators Flash Continuously 15 Seconds or More

Circuit Description

This symptom is usually the result of actions expected to take place during the transition of a transfer case mode change, which has not happened. When the transfer case changes from 2WD to 4WD, for example, the front axle is Locked by the transfer case shift control module. If the transfer case shift control module does not sense that the front axle is applied, the module waits for the action to take place before the gear change is made. While waiting, the mode switch lamp continues to flash for a period of time, at which time all other mode requests are ignored for the duration of the ignition cycle.

The front axle control circuit consists of an electric motor actuator which engages and disengages the front axle. The front axle actuator motor consists of a permanent magnetic (PM) motor, a worm gear controlled plunger, a front axle switch and an electronic control circuit all within the actuator assembly.

The front axle actuator consists of the following circuits:

    • The front axle control circuit, which is also connected to the transfer case shift control module
    • The front axle switch circuit, which is also connected to the transfer case shift control module
    • A battery feed circuit
    • A ground circuit

When a shift to AUTO 4WD, 4HI, or 4LO is requested, the transfer case shift control module engages the front axle by grounding the front axle control circuit through a current limiting driver.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. This step determines the position of the front axle switch.

    2.

  2. This step helps determine if the front axle will not engage.

    3.

  3. This step helps determine if the front axle will not disengage.

Step

Action

Yes

No

Schematic Reference: Transfer Case Control Schematics

Connector End View Reference: Transfer Case Control Connector End Views

1

Did you perform the Diagnostic System Check - Transfer Case?

Go to Step 2

Go to Diagnostic System Check - Transfer Case

2

  1. Turn the ignition ON, with the engine OFF.
  2. Install a scan tool.
  3. Using a scan tool, observe the Front Axle Switch status.

Does the scan tool display the Front Axle Switch status as Locked?

Go to Step 4

Go to Step 3

3

Using a scan tool, observe the Encoder Gear Position status.

Is the transfer case in AUTO 4WD, 4WD HI or 4WD Low mode?

Go to Front Axle Will Not Engage

Go to Step 5

4

Using a scan tool, observe the Encoder Gear Position status.

Is the transfer case in 2WD mode?

Go to Front Axle Will Not Disengage

Go to Step 5

5

Replace the transfer case shift control module. Refer to Transfer Case Shift Control Module Replacement and Transfer Case Shift Control Module Reprogramming .

Did you complete the repair?

Go to Step 6

--

6
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the conditions for the symptom to occur.

Does the symptom occur?

Go to Step 2

System OK