GM Service Manual Online
For 1990-2009 cars only

Evaporative Emission Vent Valve Replacement Utility

Removal Procedure


    Object Number: 627189  Size: SH
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the vent pipe (2) from the evaporative emission (EVAP) canister vent valve.
  3. Disconnect the EVAP canister vent valve electrical connector (3).
  4. Detach the EVAP canister vent valve from the EVAP canister vent valve bracket (1).

Installation Procedure


    Object Number: 627189  Size: SH
  1. Install the EVAP canister vent valve to the EVAP canister vent valve bracket (1).
  2. Connect the EVAP canister vent valve electrical connector (3).
  3. Connect the vent pipe (2) to the EVAP canister vent valve.
  4. Lower the vehicle.

Evaporative Emission Vent Valve Replacement Pickup

Replacement Procedure

  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the evaporative emission (EVAP) canister vent electrical connector, if equipped.
  3. Disengage the 2 vent valve pipe clips securing the pipe to the underbody.
  4. Remove the clips from the underbody and discard.

  5. Disconnect the vent valve pipe at the EVAP canister.
  6. Remove and retain the EVAP canister vent valve bracket mounting bolt.
  7. Remove the complete EVAP canister vent valve assembly with bracket attached and discard.
  8. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1962414  Size: SH

    Important: The new canister vent valve will be installed in a new location, outside of the frame.

  9. Position and secure the new valve assembly to the frame bracket on the outside of the frame using the existing hole and mounting bolt.
  10. Tighten
    Tighten the bracket mounting bolt to 12 N·m (106 lb in).

  11. Connect the vent valve pipe to the EVAP canister.
  12. Install the 2 vent valve pipe clips into the existing underbody holes.
  13. Connect the EVAP canister vent valve electrical connector, if equipped.
  14. Attach a bulk 5/8 in heater hose to the vent valve port and secure using a clamp.
  15. Cut the hose to determined length and install the supplied filter box. Secure using a clamp.

  16. Object Number: 1962416  Size: SH
  17. Secure the filter box to the fuel lines above the transmission using a tie strap.
  18. The filter box opening should be pointing downward.

  19. Tie strap the hose as needed along the frame rail in order to keep the hose away from the pinch-points and heat sources.
  20. Lower the vehicle.