GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2000 🢒 Yukon - 2WD 🢒 Engine 🢒 Engine Controls - 4.8L, 5.3L, and 6.0L 🢒 Accelerator Pedal Replacement

Removal Procedure

    Object Number: 372959 Size: SH
  1. Remove the left instrument panel insulator.
  2. Disconnect the accelerator cable retainer (3) from the accelerator pedal lever (2).
  3. Remove the end bushing retaining clips.
  4. Remove the end bushings from the pivot shaft.
  5. Remove the accelerator pedal.

Installation Procedure

    Object Number: 372959 Size: SH
  1. Install the accelerator pedal.
  2. Install the end bushings to the pivot shaft.
  3. Install the end bushing retaining clips.
  4. Install the accelerator cable through the slot in the accelerator pedal lever (2).
  5. Seat the retainer (3) in the accelerator pedal lever (2).
  6. Test for complete throttle opening and closing range by operating the accelerator pedal. Also inspect the carpet fit under the accelerator pedal. The throttle should operate freely and without binding between full closed throttle and wide open throttle (WOT).
  7. Install the left instrument panel insulator.