GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 260101  Size: SH

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  1. Disconnect the negative battery cable.
  2. Remove the engine sight shield.

  3. Object Number: 300360  Size: SH
  4. Relieve the fuel system pressure. Refer to the Fuel Pressure Relief .
  5. Disconnect the fuel feed pipe (1) and the fuel return pipe (2) from the fuel rail.

  6. Object Number: 350543  Size: SH
  7. Remove the fuel return pipe attaching screw (3) and the fuel return pipe retainer (2).
  8. Remove the fuel return pipe (1).
  9. Remove the fuel return pipe O-ring (6).
  10. Discard the O-ring (6).

Installation Procedure


    Object Number: 350543  Size: SH
  1. Lubricate the new fuel return pipe O-ring (6) with clean engine oil.
  2. Install the fuel return pipe O-ring (6) on the fuel return pipe (1).
  3. Install the fuel return pipe (1) to the left fuel rail  (14).
  4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the fuel return pipe retainer (2) and the fuel return pipe attaching screw (3).
  6. Tighten
    Tighten the fuel return pipe attaching screw (3) to 5 N·m (44 lb in)


    Object Number: 300360  Size: SH
  7. Connect the fuel return pipe (2) and the fuel feed pipe (1) to the fuel rail.
  8. Tighten the fuel filler cap.
  9. Connect the negative battery cable.
  10. Inspect for leaks.
  11. 8.1. Turn the ignition ON for 2 seconds.
    8.2. Turn the ignition OFF for 10 seconds.
    8.3. Turn the ignition ON.
    8.4. Inspect for fuel leaks.

    Object Number: 260101  Size: SH
  12. Install the engine sight shield.
  13. Tighten
    Tighten the engine sight shield bolts to 10 N·m (89 lb in)