GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 348542  Size: SH
  1. Mark the position of the wiper blade on the windshield with a suitable marker or a piece of masking tape.
  2. Disconnect the washer hose.
  3. Remove the cover from the nut on the wiper arm.
  4. Remove the nut from the wiper arm.
  5. Important: Use a battery terminal puller to remove the wiper arm if rocking the wiper arm fails to loosen it from the drive shaft.

  6. Rock the wiper arm back and forth to loosen it from the drive shaft.
  7. Remove the wiper arm from the drive shaft.
  8. Clean the knurls of the drive shaft with a wire brush.

Installation Procedure


    Object Number: 348542  Size: SH
  1. Position the wiper arm so that the wiper blade aligns with the mark made on the windshield before removal.
  2. Install the wiper arm onto the drive shaft.
  3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the nut on the drive shaft.
  5. Tighten
    Tighten to the nut to 25 N·m (18 lb ft).

  6. Install the cover on the nut.
  7. Connect the washer hose.
  8. Clean the locating mark or masking tape from the windshield.
  9. Operate the wipers and check for proper operation.