- Remove the key from the
ignition switch.
- Connect the passenger side air bag yellow 2-way connector (1)
to the vehicle harness yellow 2-way connector (2) located under
the passenger seat.
- Install the connector position assurance (CPA) to the passenger
side air bag yellow 2-way connector (2).
- Connect the driver side air bag yellow 2-way connector (1)
to the vehicle harness yellow 2-way connector (2) located under
the driver seat.
- Install the connector position assurance (CPA) to the driver side
air bag yellow 2-way connector (2).
- Connect the passenger
(IP) module yellow 2-way connector (1) to the vehicle harness
yellow 2-way connector located behind the main IP support.
- Install the CPA to the passenger (IP) module yellow 2-way
connector (1) located behind the main IP support.
- Connect the driver yellow 2-way
connector (2) to the vehicle harness yellow 2-way connector
located at the base of the steering column.
- Install the connector position assurance (CPA) (1) to the
driver yellow 2-way connector (2).
- Install the AIR BAG Fuse to the fuse block.
- Staying well away from all air bags, turn ON the ignition.
11.1. | The AIR BAG warning lamp will flash 7 times. |
11.2. | The AIR BAG warning lamp will then turn OFF. |
- Perform the Diagnostic System Check - SIR if the AIR BAG warning
lamp does not operate as described. Refer to
Diagnostic System Check - SIR
.