GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2001 🢒 Yukon - 2WD 🢒 Engine 🢒 Engine Mechanical - 8.1L 🢒 Camshaft Replacement

Removal Procedure

    Object Number: 470998 Size: SH
  1. Remove the grille. Refer to Grille Replacement in Exterior Trim.
  2. Remove the air conditioning (A/C) condenser. Refer to Condenser Replacement in Heating, Ventilation and Air Conditioning.
  3. Remove the valve lifters. Refer to Valve Lifter Replacement .
  4. Remove the timing chain and sprocket. Refer to Timing Chain and Sprocket Replacement .
  5. Remove the camshaft retainer bolts.
  6. Remove the camshaft retainer.

    7. Object Number: 471002 Size: SH
  7. Install three 8 - 1.25 x 100 mm bolts into the camshaft front bolt holes.
  8. Using the bolts as a handle, carefully rotate and pull the camshaft out of the engine block.
  9. Remove the bolts from the front of the camshaft.
  10. Clean and inspect the camshaft. Refer to Camshaft and Bearings Cleaning and Inspection in Engine Mechanical - 8.1 L Unit Repair.

Installation Procedure

    Object Number: 471002 Size: SH
  1. Apply lubricant GM U.S. P/N 12345501, Canada P/N 992704, or equivalent to the following components:
    2. • The camshaft lobes
    • The camshaft bearing journals
    • The camshaft bearings

       Notice: All camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the camshaft bearings.

  2. Install three 8 - 1.25 x 100 mm bolts into the camshaft threaded bolt holes.
  3. Using the bolts as a handle, carefully install the camshaft.
  4. Remove the bolts from the front of the camshaft.

    5. Object Number: 470998 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the camshaft retainer and bolts.

    6. Tighten
    Tighten the camshaft retainer bolts to 12 N·m (106 lb in).

  6. Install the timing chain and sprocket. Refer to Timing Chain and Sprocket Replacement .
  7. Install the valve lifters. Refer to Valve Lifter Replacement .
  8. Install the A/C condenser. Refer to Condenser Replacement in Heating, Ventilation and Air Conditioning.
  9. Install the grille. Refer to Grille Replacement in Exterior Trim.