The ignition 1 voltage circuit supplies 12 volts to the traction control switch. The EBCM illuminates the low traction indicator by applying ground to the traction control active signal circuit.
Thoroughly inspect connections or circuitry that may cause an intermittent malfunction. Refer to the following:
The number below refers to the step number on the diagnostic table.
Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Antilock Brake System Schematics | |||
1 | Did you perform the ABS Diagnostic System Check? | Go to Step 2 | |
2 |
Does the low traction indicator illuminate for 3 seconds and then turn OFF? | Go to Diagnostic Aids | Go to Step 3 |
3 |
Does the scan tool display On? | Go to Step 7 | Go to Step 4 |
Important: The EBCM sets DTC C0283 during this step if the ignition is ON for greater than 10 seconds.
Does the test lamp illuminate for 3 seconds and then turn OFF? | Go to Step 6 | Go to Step 5 | |
5 | Test the traction control active signal circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 8 | Go to Step 7 |
6 | Replace the traction control switch. Refer to Electronic Traction Control Switch Replacement . Did you complete the replacement? | Go to Step 8 | -- |
7 |
Important: Following EBCM replacement, use the scan tool to perform the Tire Size Calibration procedure. Replace the EBCM. Refer to Electronic Brake Control Module Replacement . Did you complete the replacement? | Go to Step 8 | -- |
8 |
Does the low traction indicator illuminate for 3 seconds and then turn OFF? | System OK | Go to Step 3 |