J 41352 Modular Column Holding Fixture
Important: You must check for 2 pan head tapping screws (1, 2) in the lower trim cover (3) before removal.
If no screws are present in the lower trim cover, proceed to the next step.
Important: You must check for 1 TORX® head screw (1) in the upper trim cover (2) before removal.
If no screw is present, remove the upper trim cover (2).
Important: The abrasion sleeve located on the steering column wire harness assembly must be reinstalled. Make note of what connector (electronic lock module assembly) is coming out of the middle of the abrasion sleeve for installation purposes.
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury • Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
5.1. | Tilt the lower trim cover down. |
5.2. | Slide the lower trim cover backward in order to disengage the locking tabs. |
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury • Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
Important: You must check for 2 pan head tapping screws (1,2) in the lower trim cover before removal.
If screws are not present in the lower trim cover, proceed to the next step.
Important: You must check for 2 pan head tapping screws (1,2) in the lower trim cover (3) before removal.
If a screw is not present, remove the upper trim cover (2).