Removal Procedure
- Insert a flat-bladed tool
into the slots on the power accessory switch panel in order to release the
retainer clips.
- Remove the switch panel.
- Disconnect the electrical connectors from the switches.
- Remove the screws from the switches.
- Remove the power accessory switches from the switch panel.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Install the power accessory switches to the switch panel.
Tighten
Tighten the power accessory switch screws to 2 N·m (18 lb in).
- Connect the electrical connectors to the switches.
- Position the switch panel
to the door panel.
- Install the switch panel by pressing the switch panel into place
until fully seated.