Removal Procedure
- Remove the headliner.
Refer to
Headlining Trim Panel Replacement
in Interior
Trim.
Important: Observe the routing of the wire harness. Failure to route the wire the
same will result in the wire harness being pinched during sunroof operation.
- Disconnect the wire harness connectors (5) and (6).
- Remove the wire from the sunroof module.
Installation Procedure
- Connect the wire connector
(6).
Important: Do not route the wire harness on the top or the bottom of the flange
as it will get pinched during sunroof operation.
- Secure the wire harness along the out board flange (7) and (2).
- Secure clip (1) and clip (3) to sunroof module flange.
- Loop the wire harness around cable drive (4).
- Connect the wire harness (5) to the sunroof motor.
- Install the headliner. Refer to
Headlining Trim Panel Replacement
in Interior Trim.
- Inspect the operation of the sunroof.