GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2007 🢒 Yukon - 2WD 🢒 Bulletins 🢒 Loud Buzz Or Rattle From The Right Front Fender - keywords noise vibration

Loud Buzz Or Rattle From The Right Front Fender - keywords noise vibration

Subject:Loud Buzz Or Rattle From Right Front Fender

Models:2007-2008 Cadillac Escalade, ESV, EXT
2007-2008 Chevrolet Avalanche, Silverado, Suburban, Tahoe
2007-2008 GMC Sierra, Yukon, Yukon Denali, Yukon XL, Yukon Denali XL


This PI was superseded to update model years. Please discard PIT4311.

The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI.

Condition/Concern:

Some customers may comment on a buzz or rattle type noise from the right front fender area on hard acceleration or when brake torquing. The noise is most noticeable at 1800 RPM. The noise can be heard with the radio on and you may think the air intake box is vibrating. This noise may be caused by air turbulence through the fender (from the air cleaner) causing the fender to vibrate. This noise can be isolated by removing the air snorkel (with MAF sensor attached) from the air box and driving or brake torquing the vehicle again.

Recommendation/Instructions:

If you experience this concern, please perform the following repairs:

  1. Remove the air box and Battery per SI2000 Instruction. (The Coolant bottle can also be removed if additional room is needed)
  2. Obtain Sound Deadening material from Dynamat or an equivalent material. (The Dynamat sound deadening material can be obtained from the following web site:

    3. tp://www.dynamat.com/store/store-car.asp and obtain part number: 10435. This kit P/N contains enough material to repair at least 10 vehicles.

  3. Cut out two pieces of the Dynamat material in the following dimensions: 12 X 8 and 12 X 3.
  4. Before installing the two pieces on the vehicle, lay the material in the sun or heat with a heat gun prior to installation onto the fender.
  5. Install the 8 X 12 piece of material at the airbox opening as shown below:

    6. Object Number: 1913374 Size: SH
  6. Install the 3 X 12 piece of material through the hole near the battery tray as shown below:

    7. Object Number: 1913376 Size: SH
    • Vertical Measurement 12 Inches
    • Horizontal Measurement 3 Inches
  7. The finished patches should be visible in highlighted boxes illustrated in the photo below

Object Number: 1913377 Size: SH

Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed.