Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provide an overview of each diagnostic category. |
DTC Descriptor
DTC P0650: Malfunction Indicator Lamp (MIL) Control CircuitDiagnostic Fault Information
Circuit | Short to Ground | Open | Short to Voltage | Signal Performance |
|---|---|---|---|---|
MIL Voltage Supply | P0650 | P0650 | -- | -- |
MIL Control | P0650/MIL ON | P0650* | P0650 | -- |
*The MIL Remains ON | ||||
Circuit/System Description
The malfunction indicator lamp (MIL) is located on the instrument panel cluster (IPC).
The MIL informs the driver that an emission system fault has occurred and that the engine control system requires service. The engine control module (ECM) monitors the MIL control circuit for conditions that are incorrect for the commanded states of the MIL. For example, a failure condition exists if the ECM detects low voltage when the MIL is commanded OFF, or high voltage when the MIL is commanded ON.
Conditions for Running the DTC
| • | The ignition is in the Run or Crank position. |
| • | The ignition voltage is between 9-18 volts. |
| • | The ECM has commanded the MIL ON and OFF at least once during the ignition cycle. |
| • | DTC P0650 runs continuously when the ignition is ON. |
Conditions for Setting the DTC
The ECM detects that the commanded state of the MIL driver and the actual state of the control circuit do not match for more than 5 seconds.
Action Taken When the DTC Sets
DTC P0650 is a Type B DTC.
Conditions for Clearing the MIL/DTC
DTC P0650 is a Type B DTC.
Diagnostic Aids
If the condition is intermittent, move the related harnesses and connectors with the engine operating. Monitor the scan tool Circuit Test Status parameters for the component. The Circuit Test Status parameter will change from OK or Not Run to Fault if there is a condition with the circuit or a connection.
Reference Information
Schematic Reference
Connector End View Reference
Electrical Information Reference
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Ignition ON, command the MIL ON and OFF with a scan tool. The MIL should turn ON and OFF as commanded.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Circuit/System Testing
- If any other instrument panel cluster (IPC) indicators or gages are inoperative, refer to Instrument Cluster Gages Inoperative.
- Ignition OFF, disconnect ECM X1 harness connector. Ignition ON, the MIL should not illuminate.
- Ignition ON, connect a 3A fused jumper wire between the MIL control circuit terminal X1-12 and ground. The MIL should illuminate.
- If all circuits/connections test normal, replace the ECM.
| ⇒ | If the MIL is illuminated, test the MIL control circuit terminal X1-12 for a short to ground. If the circuit tests normal, replace the IPC. |
| ⇒ | If the MIL does not illuminate, test the MIL control circuit for a short to voltage, or an open/high resistance. If the circuit tests normal, replace the IPC/bulb. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for ECM replacement, setup, and programming |
