Liftgate Center Applique Replacement. GMC Truck Yukon

For 1990-2009 cars only

Makes 🢒 GMC_Truck 🢒 2009 🢒 Yukon - 2WD 🢒 Body Hardware and Trim 🢒 Exterior Trim 🢒 Liftgate Center Applique Replacement

Liftgate Center Applique Replacement Escalade

Callout	Component Name
Procedure Remove the rear wiper motor. Refer to Rear Window Wiper Motor Replacement. Remove the 4 applique nuts from inside the liftgate panel. Release the 3 upper integral retainer clips from the exterior side of the liftgate panel. Disconnect the electrical connector.
1	Liftgate Center Applique Assembly Nut (Qty: 4) Caution: Refer to Fastener Caution in the Preface section. Tighten 6 N·m (53 lb in)
2	Liftgate Center Applique Assembly Tip Transfer the rear view camera (if equipped). Refer to Rearview Camera Replacement.

Callout

Component Name

Remove the rear wiper motor. Refer to Rear Window Wiper Motor Replacement.
Remove the 4 applique nuts from inside the liftgate panel.
Release the 3 upper integral retainer clips from the exterior side of the liftgate panel.
Disconnect the electrical connector.

Liftgate Center Applique Assembly Nut (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
6 N·m (53 lb in)

Liftgate Center Applique Assembly

Tip
Transfer the rear view camera (if equipped). Refer to Rearview Camera Replacement.

Callout	Component Name
Procedure Open the liftgate. Remove the rear wiper motor. Refer to Rear Window Wiper Motor Replacement. Remove the 4 applique nuts from inside the liftgate panel. Release the 2 integral retainers from the exterior side of the applique.
1	Liftgate Center Applique Assembly Nut (Qty: 4) Caution: Refer to Fastener Caution in the Preface section. Tighten 6 N·m (53 lb in)
2	Liftgate Center Applique Harness Grommet Tip Ensure the grommet is secure to the liftgate panel hole prior to the installation of the applique.
3	Liftgate Center Applique Assembly Tip Transfer the rear view camera (if equipped). Refer to Rearview Camera Replacement.

Callout	Component Name
Preliminary Procedures Open the liftgate. Remove the rear wiper motor. Refer to Rear Window Wiper Motor Replacement. Remove the 4 applique nuts from inside the liftgate panel. Release the 2 integral retainers from the exterior side of the applique.
1	Liftgate Center Applique Assembly Nut (Qty: 4) Caution: Refer to Fastener Caution in the Preface section. Tighten 6 N·m (53 lb in)
2	Integral Retainer (Qty: 2)
3	Rear Liftgate Harness Electrical Connector Tip Disconnect the electrical connector after releasing the retainers.
4	Liftgate Center Applique Assembly Procedure Pull the applique rearward in order to release the 2 outer integral clips. Transfer the rear view camera (if equipped). Refer to Rearview Camera Replacement.