Rear Wheel Opening Flare Replacement. GMC Truck Yukon

For 1990-2009 cars only

Makes 🢒 GMC_Truck 🢒 2009 🢒 Yukon - 2WD 🢒 Body Hardware and Trim 🢒 Exterior Trim 🢒 Rear Wheel Opening Flare Replacement

Callout	Component Name
1	Rear Wheel Opening Flare Assembly Retainer (Qty: 4)
2	Rear Wheel Opening Flare Assembly Screw (Qty: 4) Caution: Refer to Fastener Caution in the Preface section. Tighten 2 N·m (18 lb in)
3	Rear Wheel Opening Flare Assembly Tip The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength. Clean area where flare will be mounted. Use a suitable solvent, such as flash naphtha or a mix of 50 percent isopropyl alcohol and 50 percent water by volume. Warm body panel with a J-25070 Heat Gun to a minimum 21°C (70°F) prior to flare installation. Do not touch adhesive surface when tape is removed. Peel the tape liner once the flare has been installed and wet out. Special Tools J-25070 Heat Gun

Callout

Component Name

Rear Wheel Opening Flare Assembly Retainer (Qty: 4)

Rear Wheel Opening Flare Assembly Screw (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
2 N·m (18 lb in)

Rear Wheel Opening Flare Assembly

Tip

The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
Clean area where flare will be mounted. Use a suitable solvent, such as flash naphtha or a mix of 50 percent isopropyl alcohol and 50 percent water by volume.
Warm body panel with a J-25070 Heat Gun to a minimum 21°C (70°F) prior to flare installation.
Do not touch adhesive surface when tape is removed. Peel the tape liner once the flare has been installed and wet out.

J-25070 Heat Gun