Installation Procedure
- Install the thrust selective washer on the input housing.
- Install the stator shaft/selective washer o-ring assembly on the
input housing.
The black race on the bearing goes toward the oil pump.
- Install the reverse input clutch on the input clutch assembly.
- Index the reverse input clutch plates with the input clutch hub.
Make certain all clutch plates are fully engaged.
- Install the reverse input and the input clutch assembly into the transmission
case.
- Index the 3rd and 4th clutch plates with the input internal gear.
• | Ensure that all clutch plates are fully engaged. |
• | When properly assembled, the reverse input clutch housing will
be located just below the case oil pump face. |