GM Service Manual Online
For 1990-2009 cars only

Object Number: 56429  Size: LF
Engine Controls Components
DIESEL PCM, MAF, EGR, APP, WASTEGATE
OBD II Symbol Description Notice
Handling ESD Sensitive Parts Notice

Circuit Description

The PCM operates a PWM solenoid to control the EGR valve. This solenoid is normally open. By providing a ground path the PCM energizes the solenoid which then allows vacuum to pass to the EGR valve. During normal operation, the PCM compares its desired MAF signal with the measured MAF signal and makes corrections in the duty cycle accordingly. This is a type B DTC.

Conditions for Setting the DTC

    • Five ALM Cells that are less than .5.

Action Taken When the DTC Sets

The PCM will shut down the EGR.

Conditions for Clearing the MIL/DTC

    • The PCM will turn the MIL off after three consecutive trips without a fault condition.
    • A History DTC will clear when forty consecutive warm-up cycles that the diagnostic does not fail (coolant temperature has risen 5°C (40°F) from start up coolant temperature and engine coolant temperature exceeds 71°C (160°F) that same ignition cycle.
    • Use of a Scan tool

Diagnostic Aids

The most likley cause of failure is a condition causing low back pressure.

To run the diagnostic test the engine must be at the operating temperature, vehicle in drive at idle for approximately 1 minute, then with the vehicle in park hold engine rpm steady between 1500 and 2100 rpm for 30 seconds. If the diagnostic test fails to run, vehicle must be driven.

The Adaptive Learn Matrix (ALM) is used to adjust the EGR vacuum control based on Mass Air Flow (MAF). The ALM may change as a result of back pressure increases over the life of the vehicle or other engine system variations. The ALM is made up of sixteen cells (numbered from zero to fifteen) in which each cell covers a range of engine speed (RPM) and load (mm3).

Test Description

Number(s) below refer to the step number(s) on the Diagnostic Table.

  1. This step checks for a low back pressure problem.

Step

Action

Value(s)

Yes

No

1

Important: Before clearing DTC(s) use the scan tool Capture Info to record freeze frame and failure records for reference, as data will be lost when Clear Info function is used.

Was the Powertrain On-Board Diagnostic (OBD) System Check performed?

--

Go to Step 2

Go to Powertrain On Board Diagnostic (OBD) System Check

2

Are there any other EGR DTCs set?

--

Go to the applicable DTC Table

Go to Step 3

3

Check for the following conditions:

    • Plugged EGR ports.
    • Exhaust system leaks.
    • Exhaust system modifications.

Has a repair been performed?

--

Go to Step 4

--

4

Important: After repairs, the EGR ALM cells must be reset (under special functions in scan tool).

Are EGR ALM cells reset?

--

Go to Step 5

--

5

  1. Using the Scan Tool, select DTC, Clear Info.
  2. Start the engine and idle at normal operating temperature.
  3. Select DTC, Specific, then enter the DTC number which was set.
  4. Operate the vehicle until the Scan Tool indicates that the diagnostic Ran.

Does the Scan Tool indicate that the diagnostic Passed?

--

Go to Step 6

Go to Step 2

6

Using the Scan Tool, select Capture Info, Review Info.

Are any DTCs displayed that have not been diagnosed?

--

Go to the Applicable DTC Table

System OK