A dash light is illuminated by the PCM if diagnostics have detected certain errors related to the engine performance or engine sensor status. When the PCM is commanding the MIL ON, the voltage potential of the circuit will be low (near 0 volts). When the PCM is commanding the MIL OFF, the voltage potential of the circuit will be high (near battery voltage). The primary function of the PCM is to supply the ground for the MIL circuit.
The ignition switch in the ON position.
The voltage on MIL control circuit high (near battery voltage) when the MIL is requested ON.
or
Voltage on MIL control circuit low (near 0 volts) when the MIL is requested OFF.
• | The PCM will not illuminate the malfunction indicator lamp (MIL). |
• | The PCM records the operating conditions at the time the diagnostic fails. This information is stored in the Failure Records. |
• | A History DTC clears after forty consecutive warm-up cycles, if this or any other emission related diagnostic does not report any failures |
• | The use of a scan tool. |
A faulty bulb, the control circuit shorted to ground or battery voltage, will cause a P1641 to set.
An intermittent can be caused by the following:
• | Poor connections |
• | Rubbed through wire insulation |
• | Broken wire inside the insulation |
Number(s) below refer to the step number(s) on the Diagnostic Table.
Be sure that both the ON and the OFF states are commanded. Repeat the commands as many times as necessary.
If no trouble is found in the control circuit or the connection at the PCM, the PCM maybe malfunctioning, however, this is an extremely unlikely failure.
Step | Action | Value(s) | Yes | No | ||||||
---|---|---|---|---|---|---|---|---|---|---|
1 |
Important: Before clearing any DTCs, use the scan tool Capture Info to save freeze frame and failure records for reference, as the Scan tool loses data when using the Clear Info function. Was the Powertrain On-Board Diagnostic (OBD) System Check performed? | -- | ||||||||
Does the lamp turn ON and OFF with each command? | -- | |||||||||
3 | The DTC is intermittent. If no additional DTCs are stored, refer to Diagnostic Aids. If additional DTCs were stored refer to those table(s). Are any additional DTCs stored? | -- | Go to the Applicable DTC table | Go to Diagnostic Aids | ||||||
4 |
Is the lamp OFF? | -- | ||||||||
5 |
Is the lamp ON? | -- | ||||||||
6 |
Was a repair performed? | -- | ||||||||
7 | The MIL control circuit is shorted to ground, repair as necessary. Is the action complete? | -- | -- | |||||||
8 | Check the MIL circuit for the following:
Is the repair complete? | -- | -- | |||||||
Replace the PCM. Important: The new PCM must be programmed. Refer to Powertrain Control Module Replacement/Programming .Is the action complete? | -- | -- | ||||||||
10 |
Does the Scan Tool indicate the diagnostic Passed? | -- | ||||||||
11 | Does the Scan tool display any additional undiagnosed DTCs? | -- | Go the Applicable DTC Table | System OK |