Will the remote control door lock receiver program but not change operating modes?

--

Go to Step 2

Go to Keyless Entry Does Not Program

1. Disconnect remote control door lock receiver connector.
2. Connect a J 39200 J 39200 DMM, set on volts, between cavity J and ground.
3. Place the ignition switch in the ON position.

Is there battery voltage?

--

Go to Step 3

Go to Step 4

Replace the remote control door lock receiver. Refer to Remote Control Door Lock Receiver Replacement Remote Control Door Lock Receiver Replacement .

Is the repair complete?

--

Go to Transmitter Programming Transmitter Programming (Base )

--

Repair open in CKT 39 (PNK) between remote control door lock receiver and the I/P fuse block. Refer to Wiring Repairs Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Transmitter Programming Transmitter Programming

--