Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle 708 Model

1. Loosen and remove the adjuster lock nut (1).
2. Remove the bolts (2).
3. Rotate the stub shaft (6) using a 12-point socket in order to center the steering gear (7).
4. Remove the following items as an assembly:

•	The side cover (8)

•	The gasket (3)

•	The pitman shaft (4)

5. Remove the pitman shaft (4) from the side cover (8).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Screw the pitman shaft (4) to the side cover (8) until it fully seats to the side cover (8).
2. Install the adjuster lock nut (1). Do not tighten the adjuster lock nut (1) until the pitman shaft adjustment is completed.
3. Install the gasket (3) to the side cover (8).
4. Bend the gasket tabs around the edges of the side cover (8).
5. Install the pitman shaft assembly (4) and the side cover (8) to the steering gear housing (7).
6. Install the bolts (2).

Tighten
Tighten the bolts (2) to 60 N·m (44 lb ft).

7. In order to adjust the pitman shaft (4), refer to Steering Gear Pitman Shaft Over-Center Preload Adjustment - Off Vehicle .