Vehicle Speed Sensor and Case Extension Removal 2WD Truck/Utility/Van Only
Removal Procedure
Tools Required
J 29837-A Output
Shaft Support Fixture
- Remove the sensor retaining bolt (35).
- Remove the speed sensor (36) and O-ring seal (37).
- Remove the case extension
bolts (32).
- Remove the case extension (31) and the case extension to
case seal (30).
- Remove the output shaft sleeve (690) and the output shaft
O-ring seal (691). Not all models use an output shaft sleeve (690)
and O-ring seal (691).
- Install the J 29837-A
.
If the J 29837-A
is not used, the output shaft (687) may fall free when the input carrier
retaining ring is removed.