The quarter panel can be serviced as a complete panel or sectioned. When complete panel replacement is performed, the roof panel must be removed and replaced. For sectioning, the quarter panel can be replaced by making sectioning cuts at the window pillars.

1. Remove all related panels and components.
2. Restore as much of the damage as possible to factory specifications.
3. Note the location and remove the following as necessary:

•

Sealers

•	Sound deadeners

•	Anti-corrosion materials

Important: Do not damage the inner panels or reinforcements.

4. Cut the quarter panel in the location where sectioning is to be performed.
5. Locate and drill out all factory welds. Note the number and location of the welds for installation of the service part.
6. Remove the damaged quarter panel section.

1. Cut the replacement quarter panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half times the metal thickness at the sectioning joint.
2. Create a 50 mm (2 in) backing plate from the unused portion of the service part. Trim the backing plate as necessary to fit behind the sectioning joint.
3. Drill 8 mm (5/16 in) plug weld holes along the sectioning cut on the remaining original panel. Locate these holes 13 mm (1/2 in) from the edge and spaced 40 mm (1-½ in) apart.

Caution: Foam sound deadeners must be removed from areas within 152.4 mm (6 in) of where flame is to be used for body repairs. When reinstalling foam sound deadeners, avoid inhaling fumes as bodily injury may result.

Important: In any area damaged beyond recognition, space plug weld holes every 40 mm (1-½ in) apart.

4. Drill 8 mm 5/16 in) plug weld holes in the service panel as necessary in the locations noted from the original panel and along the sectioning cut.
5. Prepare all attachment surfaces as necessary.
6. Apply weld-thru primer to all bare metal surfaces.
7. Fit the backing plate (2) halfway into the sectioning joint, clamp and plug weld to the vehicle.
8. Align the quarter panel to adjacent panels (3) using three-dimensional measuring equipment. Leave a gap of one-and-one-half times the metal thickness at the sectioning joint.
9. Plug weld accordingly.
10. To create a solid joint with minimal heat distortion to make 25 mm (1 in) stitch welds along the seam with 25 mm (1 in) gaps between them, then go back and complete the stitch weld.
11. Clean and prepare all welded surfaces.

Important: Prior to refinishing, refer to publication GM 4901M-D-2000 "GM Approved Refinish Materials" for recommended products. Do not combine paint systems. Refer to paint manufacturer's recommendations.

12. Apply the following as necessary:

•	an approved anti-corrosion primer

•	sound deadening materials

•	sealers and refinish materials

13. Install all related panels and components.