GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2000 🢒 Yukon - 4WD 🢒 Body and Accessories 🢒 Cellular Communication 🢒 OnStar Call Center Unable to Configure OnStar (R) System

Test Description

The following procedure diagnoses the "Unable to Configure the OnStar® System" message from the OnStar® Call Center.

  1. This step tests the configuration of the OnStar® system.

    2.

  2. This step tests for an open in the IGN SEN circuit.

    3.

  3. This step tests for a short to ground or an open in the ignition positive circuit.

Step

Action

Value(s)

Yes

No

1

Did you perform the OnStar® Diagnostic System Check?

--

Go to Step 2

Go to OnStar System Check

2
  1. Turn ON the ignition, with the engine OFF.
  2. Activate the OnStar® Call Center button.
  3. Ask the OnStar® Call Center operator to configure the vehicle.
  4. Activate the Call End button.

Did the OnStar® Call Center operator say that the vehicle was configured?

--

Go to Step 5

Go to Step 3

3

Test the IGN SEN circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the problem?

--

Go to Step 5

Go to Step 4

4

Test the ignition positive voltage circuit for an open or a short to ground . Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the problem?

--

Go to Step 5

Go to Step 2

5

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 2