Removal Procedure
Important: Mark, organize, and sort the cylinder head components. Return the components to their original location during reassembly.
- Remove the valve rocker arm cover. Refer to
Valve Rocker Arm Cover Replacement - Left Side
and/or
Valve Rocker Arm Cover Replacement - Right Side
.
- Remove the valve rocker arm nuts, the valve rocker arm balls, and valve rocker arms.
Important: The exhaust valve pushrods (2) are longer than the intake valve pushrods (1).
- Remove the valve pushrods.
- Remove the valve rocker arm studs and pushrod guides.
- Clean and inspect the valve rocker arms and pushrods. Refer to
Valve Rocker Arm and Push Rod Cleaning and Inspection
.
Installation Procedure
Important: Be sure to keep parts in order. Parts must be put back from where they were removed.
Notice: Refer to Fastener Notice in the Preface section.
- Apply sealant to the valve rocker arm stud-to-cylinder head threads. Refer to
Adhesives, Fluids, Lubricants, and Sealers
for the correct part number.
- Install the pushrod guides and valve rocker arm studs.
Tighten
Tighten the studs to 50 N·m (37 lb ft).
Important: The exhaust valve pushrods (2) are longer than the intake valve pushrods (1).
- Install the valve pushrods.
- Coat the valve rocker arm and valve rocker arm ball bearing surfaces with lubricant. Refer to
Adhesives, Fluids, Lubricants, and Sealers
for the correct part number.
- Install the valve rocker arms, the valve rocker arm balls, and the valve rocker arm nuts.
Tighten
Tighten the nuts slowly to 25 N·m (18 lb ft) while guiding the tips of the rocker arms over the tips of the valves.
- Install the valve rocker arm cover. Refer to
Valve Rocker Arm Cover Replacement - Left Side
or
Valve Rocker Arm Cover Replacement - Right Side
.