Tools Required
• | J 43320 Crankshaft
Rear Seal Puller |
• | J 42849 Crankshaft
Rear Seal Installer |
Removal Procedure
- Remove the flywheel. Refer to
Engine Flywheel Replacement
.
- Install the guide pins from J 43320
into the crankshaft.
- Install the J 43320
over the guide pins.
- Using a suitable drill, insert eight of the self-drilling sheet
metal screws into the rear crankshaft seal, using a criss-cross pattern. The
self-tapping screws are included with the J 43320
.
- Thread the center bolt
of J 43320
into the crankshaft
to remove the seal.
- Remove the guide pins from the crankshaft.
Installation Procedure
- Make sure the crankshaft is free of grit, loose rust, and burrs. Correct
as needed.
- Apply a very light film of oil onto the crankshaft sealing surface.
DO NOT apply oil to the sealing surface of the engine block.
- Install the seal onto J 42849
.
- Position the J 42849
against the crankshaft. Thread the attaching screws into the tapped
holes in the crankshaft.
- Tighten the screws securely with a screwdriver in order to ensure
that the seal is installed squarely over the crankshaft.
- Rotate the center nut until the J 42849
bottoms.
- Remove the J 42849
.
- Install the flywheel. Refer to
Engine Flywheel Replacement
.