Removal Procedure
- Raise and suitably support
the vehicle. Refer to
Lifting and Jacking the Vehicle
in General Information.
- Remove the oil pan drain plug and allow the engine oil to drain
completely.
- Clean the oil pan drain plug surface.
- Remove the oil filter (2) from the engine block and allow the
engine oil to drain completely.
- Clean the oil filter surface.
Installation Procedure
- Install a new oil filter
(2) to the engine block. Tighten the oil filter per the oil filter manufacturers
instruction printed on the oil filter box.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the oil pan drain plug.
Tighten
Tighten the plug to 28 N·m (21 lb ft).
- Lower the vehicle.
- Fill the engine with oil. Refer to
Fluid and Lubricant Recommendations
in Maintenance and Lubrication.