Removal Procedure
- Disconnect the license plate lamp harness.
- Remove the impact bar nut (1).
- Remove the plate nuts (2).
- Remove the lower frame rail to bracket bolt (3).
- Remove the side frame rail to bracket bolt (4).
- Remove the rear trailer hitch to bumper bolts (1), if equipped.
- Remove the rear bumper from the vehicle.
Installation Procedure
- Position the rear bumper onto the vehicle.
- Install the rear trailer hitch to bumper bolts (1), if equipped.
Notice: Refer to Fastener Notice in the Preface section.
- Install the impact bar nut (1).
Tighten
Tighten the impact bar nut (1) to 50 N·m (37 lb ft).
- Install the plate nuts (2).
Tighten
Tighten the plate nuts (2) to 90 N·m (66 lb ft).
- Install the lower frame rail to bracket bolt (3).
Tighten
Tighten the lower frame rail to bracket bolt (3) to 100 N·m (74 lb ft).
- Install the side frame rail to bracket bolt (4).
Tighten
Tighten the side frame rail to bracket bolt (4) to 40 N·m (30 lb ft).
- Install the bumper step pad. Refer to
Rear Bumper Step Pad Replacement
.
- Install the license plate lamp harness.