GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the trim panel. Refer to Front Side Door Trim Panel Replacement or to Rear Side Door Trim Panel Replacement .
  2. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .

  3. Object Number: 348458  Size: SH
  4. Remove the outside handle rod from the rod clip.

  5. Object Number: 348455  Size: SH
  6. Remove the lock cylinder rod from the rod clip.
  7. Apply masking tape across the door handle on the outside of the door to secure the handle while removing the nuts.
  8. Remove the outside handle mounting nuts.

  9. Object Number: 373162  Size: SH
  10. Remove the rubber cover in order to access the outboard nut.
  11. Remove the door-lock cylinder from the outside handle housing.
  12. In order to repair a binding lock cylinder, refer to Lock Cylinder Binding .


    Object Number: 348457  Size: SH
  13. Remove the handle.

Installation Procedure


    Object Number: 348457  Size: SH
  1. Install the handle to the vehicle.
  2. If the lock cylinder is replaced, apply lubricant GM P/N 12345120, Canadian P/N 726548, or equivalent, to the inside of the lock case and of the cylinder keyway.
  3. Install the door-lock cylinder to the outside handle housing.
  4. In order to code a new lock cylinder, refer to Key and Lock Cylinder Coding in General Information.


    Object Number: 348455  Size: SH
  5. Install the lock cylinder clip to the lock cylinder rod.

  6. Object Number: 348458  Size: SH
  7. Install the handle rod to the handle assembly clip.
  8. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  9. Install the outside handle mounting nuts.
  10. Tighten
    Tighten the nuts to 9 N·m (80 lb in).


    Object Number: 373162  Size: SH
  11. Install the rubber cover.
  12. Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
  13. Install the trim panel. Refer to Front Side Door Trim Panel Replacement or to Rear Side Door Trim Panel Replacement .