When the radio is powered up, the radio supplies low level audio signals to the speakers. If the vehicle is equipped with an audio amplifier, the amplifier will boost the signal sent to the speakers. The radio tests the speaker output circuits for a short to voltage or ground.
This diagnostic procedure supports the following DTCs:
• | DTC B1025 Audio Output 1 (Left Front) Circuit |
• | DTC B1035 Audio Output 2 (Right Front) Circuit |
• | DTC B1045 Audio Output 3 (Left Rear) Circuit |
• | DTC B1055 Audio Output 4 (Right Rear) Circuit |
The test is performed when the radio switches from OFF to ON. The radio will continue to test for the fault once every 0.5 seconds.
The radio sets a current status for this DTC when a short to ground or voltage is detected on any of the speaker channels for 1.5 seconds.
No sound is present from one or more of the speakers.
The condition is no longer present for 5 seconds.
The number below refers to the step number on the diagnostic table.
Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Radio/Audio System Schematics Connector End View Reference: Entertainment Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
Did you find and correct the condition? | Go to Step 6 | Go to Step 3 | |
3 | Inspect for poor connections at the harness connector of the speaker. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 6 | Go to Step 4 |
4 | Inspect for poor connections at the harness connector of the radio. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems Did you find and correct the condition? | Go to Step 6 | Go to Step 5 |
5 | Replace the radio. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? | Go to Step 6 | -- |
6 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |