Stub Shaft Housing Replacement 670 Gear
Disassembly Procedure
Important: Replace the housing if the stub shaft housing, seal or bearing are damaged.
- Remove the stub shaft housing bolts (4) from the stub shaft housing (3).
- Remove the stub shaft housing (3) from the steering gear.
- Remove the stub shaft housing O-rings (1) (2) from the steering gear.
Assembly Procedure
- Grease the stub shaft seal with the special grease supplied with the new stub shaft housing.
- Install the new stub shaft housing O-rings (1, 2).
- Install the stub shaft housing (3) onto the steering gear.
Notice: Refer to Fastener Notice in the Preface section.
- Install the stub shaft housing bolts (4) into the stub shaft housing (3).
Tighten
Tighten the stub shaft housing bolts to 63 N·m (46 lb ft).