GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2006 🢒 Yukon - 4WD 🢒 HVAC 🢒 Heating, Ventilation and Air Conditioning 🢒 Compressor Clutch Plate/Hub Assembly Replacement

Removal Procedure

    Object Number: 370869 Size: SH
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle
  2. Remove the engine protection shield. Refer to Engine Protection Shield Replacement .
  3. Install a ratchet into the air conditioning (A/C) belt tensioner adapter opening.
  4. Rotate the A/C belt tensioner clockwise in order to relieve the tension on the belt.
  5. Remove the A/C belt from the A/C compressor.
  6. Slowly release the tension on the A/C belt tensioner.

    7. Object Number: 667064 Size: SH
  7. Remove the clutch plate retaining bolt (1).
  8. Remove the clutch plate assembly (2).
  9. Remove the clutch hub/bearing snap ring (3).
  10. Remove the clutch hub/bearing assembly (4).
  11. Remove the snap ring (5) from the clutch coil (6).
  12. Remove the clutch coil (6) from the A/C compressor (7).

Installation Procedure

    Object Number: 667064 Size: SH
  1. Install the clutch coil (6) to the A/C compressor (7).
  2. Install the snap ring (5) to the clutch coil (6).
  3. Install the clutch hub/bearing assembly (4).
  4. Install the clutch hub/bearing snap ring (3).
  5. Place a small amount of oil on the thinnest air gap shim and place it inside the clutch plate.

    6. Object Number: 872556 Size: SH
  6. Install the clutch plate assembly (2).

    7. Object Number: 187363 Size: SH

    Important: Ensure the drive plate does not drag against the pulley when the pulley is rotated.

  7. Measure the air gap between the pulley and the drive plate. Adjust the shims to achieve a 0.35-0.65 mm (0.014-0.026 in) air gap.

    8. Notice: Refer to Fastener Notice in the Preface section.

  8. Install the clutch plate retaining bolt (1).

    9. Tighten
    Tighten the bolt to 18 N·m (13 lb ft).


    Object Number: 370869 Size: SH
  9. Install a ratchet into the A/C belt tensioner adapter opening.
  10. Rotate the A/C belt tensioner clockwise in order to relieve the tension on the belt.
  11. Install the A/C belt to the A/C compressor.
  12. Slowly release the tension on the A/C belt tensioner.
  13. Remove the ratchet from the A/C belt tensioner.
  14. Install the engine protection shield. Refer to Engine Protection Shield Replacement .
  15. Lower the vehicle.