GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 34028 Inner Tie Rod Wrench

Removal Procedure

  1. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
  2. Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .

  3. Object Number: 865341  Size: SH
  4. Remove the steering linkage inner tie rod (1) from the relay rod using wrench J 34028  (2).

Installation Procedure

  1. Remove all traces of oil, grease, or other contaminants.
  2. Clean the threads of the steering linkage inner tie rod with denatured alcohol or the equivalent and allow to dry.
  3. Apply red LOCTITE™ threadlocker, GM P/N 12345493 (Canadian P/N 10953488) to the threads of the steering linkage inner tie rod.
  4. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 865341  Size: SH
  5. Install the steering linkage inner tie rod (1) to the relay rod using wrench J 34028  (2).
  6. Tighten
    Tighten the steering linkage inner tie rod to 100 N·m (74 lb ft).

  7. Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
  8. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
  9. Adjust the front toe. Refer to Front Toe Adjustment .