For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0569 00: System Configuration ErrorCircuit/System Description
The electronic brake module (EBCM) receives a serial data message from each of the network modules. Each module contains its own unique identification (ID) code that must be programmed into a new the EBCM.
Conditions for Running the DTC
Ignition ON.
Conditions for Setting the DTC
The EBCM has not undergone the programming procedure.
Action Taken When the DTC Sets
| • | The EBCM disables the ABS/traction control system (TCS)/vehicle stability enhancement system (VSES) for the duration of the ignition cycle. |
| • | The ABS indicator illuminates. |
| • | The red Brake indicator illuminates. |
| • | The Stability Control indicator illuminates. |
| • | The driver information center (DIC) displays All Wheel Drive OFF, Service StabiliTrak and Service Traction Control messages. |
Conditions for Clearing the DTC
A current DTC will clear when the EBCM is programmed.
Diagnostic Aids
A newly replaced EBCM will set DTC C0569 on its initial ignition ON cycle.
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Verify that C0569 is not set.
| ⇒ | If the DTC is set, program the EBCM. If the DTC resets, replace the EBCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM replacement, setup, and programming
