Preliminary Procedures
- Apply two layers of wide masking tape just under the bottom edge of the fender ornament to protect the body panel paint surface.
Notice: Refer to Exterior Trim Emblem Removal Notice in the Preface section. - Insert plastic pry tool to the gap between vent and fender panel.
- Disengage the two bottom retainers.
- Release the adhesive tape from each end of the center bar on the molding.
- If either of the retainers fails to release, cut or snip the retainers from the front side of the fender, if the retainers are cut a new ornament will be required.
- If retainers fail to the chrome bezel, a new ornament will to be required.
- Using a mixture of 50/50 isopropyl alcohol and clean drinkable water, remove any adhesive residue prior to installing the new fender molding insert.
- Dry the fender panel opening with a clean dry lint-free towel.
|