Tools Required
• | J 23075 Third Clutch Spring
Compressor |
- Lubricate the third clutch piston inner
seal (321) with DEXRON® III automatic transmission fluid.
- Install the third clutch piston inner seal (321). The seal lip
faces the bottom of the housing.
- Lubricate the third clutch piston outer
seal (320) with DEXRON® III automatic transmission fluid.
- Install the third clutch piston outer seal (320). The seal lip
faces away from the spring seat.
- Install
J 23084
onto the third clutch piston (322).
- Install the third clutch piston into the clutch drum (319).
- Remove
J 23084 .
- Install the third clutch piston return
springs (229).
- Install the spring seat (324).
- Place the retaining ring (325) onto the housing.
- Place the third clutch housing and input
shaft assembly (319) in a press with the turbine shaft facing down.
- Compress the third clutch piston springs using
J 23075 and
J 23075-12 .
Do not over stress the springs and seat. This will cause damage to the spring
seat.
- Install the spring seat retainer ring (325).
- Remove the tools.
- Place the third clutch housing and input
shaft assembly (319) upright into a soft jawed vise.
- Install the third clutch cushion plate (338) into the third clutch
housing. The bevel faces toward the third clutch housing (convex).
- Install the third clutch plates into the third clutch housing
beginning with a steel plate (326) and alternating with a composite plate
(327).
- Align the third clutch plates inner tangs.
- Install the turbine shaft to sun gear
bearing (330) and thrust washers (329, 332).