GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Generic 🢒 2000 🢒 Unit Repair 🢒 Body and Accessories 🢒 Doors 🢒 Front Side Door Window Regulator Motor Replacement

Removal Procedure
  1. Raise the window glass.

    2. If the window motor is inoperable, remove the glass window to gain access to the window motor retaining screws. Refer to Front Side Door Window Replacement .

  2. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
  3. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
  4. Remove the door speaker. Refer to Speaker Replacement in Entertainment.
  5. Support the glass.
  6. Disconnect the wiring harness from the window regulator motor.

    7. Object Number: 767037 Size: SH
  7. Remove the 3 bolts (1) from the window regulator motor located on the front side of the motor.

    8. Important: Do not allow the cable gear to come out of the housing. Failure will result in the cable coming off the spool.

  8. Separate the motor from the cable housing by wiggling the window motor.

    9. Observe the orientation of the window motor.

  9. Remove the motor from the window regulator assembly.

Installation Procedure

    Object Number: 767037 Size: SH
  1. Install the window motor to the cable housing by wiggling it into place.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the 3 bolts (1) to the window regulator motor.

    3. Tighten
    Tighten the bolts to 5 N·m (44 lb in).

  3. Install the glass window, if removed. Refer to Front Side Door Window Replacement .
  4. Connect the wiring harness to the window regulator motor.
  5. Remove the window support.
  6. Connect the wire connector to the switch to inspect the operation of the window.

    7. After inspection disconnect the wire harness and continue the installation.

  7. Install the speaker. Refer to Speaker Replacement in Entertainment.
  8. Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
  9. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .