Tools Required

J 36660-A Torque Angle Meter

1. Install the dowel pins (cylinder head locator) (if necessary).
2. Inspect the dowel pins (cylinder head locator) for proper installation.
3. Install the cylinder head gasket.



4. Install the cylinder head.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the cylinder head bolts.

Tighten
Tighten the cylinder head bolts in sequence to 50 N·m (37 lb ft). Turn the bolts an additional 95 degrees using the J 36660-A .