Seat Belt Retractor Replacement - No. 4 Right Rear for Generic Unit Repair 2001

Seat Belt Retractor Replacement - No. 4 Right Rear Model

1. Remove the seat belt escutcheon from the rear corner garnish molding.
2. Remove the rear corner garnish molding. Refer to Garnish Molding Replacement- Rear Corner in Interior Trim.



3. Remove the seat belt retractor retaining bolts from the seat belt retractor.
4. Remove the seat belt retractor from the vehicle.

1. Install the seat belt retractor to the vehicle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the seat belt retractor retaining bolts to the vehicle.

Tighten

•	Tighten the seat belt retractor upper retaining bolt to XX N·m (XX lb ft).

•	Tighten the seat belt retractor lower retaining bolt to XX N·m (XX lb in).

3. Install the rear corner garnish molding. Refer to Garnish Molding Replacement- Rear Corner in Interior Trim.
4. Secure the seat belt escutcheon to the rear corner garnish molding.