Front Fender Rear Molding Replacement Model

Tools Required

J25070 Heat Gun

1. Remove the rocker panel molding. Refer to Molding Replacement-Rocker Panel.
2. Remove the push pin retainer on the bottom of the molding securing the molding to the rocker panel retainer.
3. Remove three screws securing the front fender rear molding to the fender.
4. Remove the molding.

4.1.	Heat the molding using a J25070. Hold the heat gun approximately 152 mm (6 inches) from surface.

Apply heat using a circular motion for about 30 seconds.

Important: Be careful not to damage the paint.

4.2.	Peel the front fender rear molding from the panel surface using a flat-bladed tool.

4.3.	Remove all adhesive from the fender and the back of the molding using a 3M™ scotch brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.

4.4.	Clean the body panel using Varnish Makers and Painters (VMP) naphtha.

1. Ensure that the painted body surfaces in the tape contact area is clean and dry.
2. Warm the body panel with a heat lamp to a minimum of 21°C (70°F).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the front fender rear molding to the fender with three screws:

3.1.	Install the middle screw first.

3.2.	Install the top screw second while pushing the molding inboard.

Tighten
Tighten the front fender rear molding screws to XX N·m (XX lb in).

4. Peel the backing from the adhesive on the molding.

Important: Do not touch the adhesive backing.

5. Press the molding to the body.
6. Hand roll the front fender rear molding to the body in order to ensure proper adhesion.
7. Install the push pin retainer through the hole in the bottom of the molding into the rocker panel retainer.
8. Install the rocker panel molding. Refer to Molding Replacement-Rocker Panel