Emblem/Nameplate Repair Model

Important: Apply in an environment that is free from dust or other dirt that can come in contact with the sticky backing. The dirt can cause improper adhesion.

1. Clean the area where you will mount the molding or the emblem/nameplate.

Use a suitable solvent, such as mixture of 50 percent alcohol and 50 percent water or an equivalent mixture, in order to clean the areas.

2. Dry the areas thoroughly.
3. Area should be at room temperature 17- 32°C (60-90°F).
4. Ensure that the emblem/nameplate is at room temperature 17- 32°C (60-90°F). Place the emblem/nameplate, with the adhesive side down, on a heated surface or use a heat gun or a heat lamp if needed.
5. Remove the protective liner from the back of the emblem/nameplate.



6. Apply the emblem/nameplate to the body surface.



7. Apply pressure to the emblem/nameplate in order to wet out the adhesive.
8. Apply equal pressure along the emblem/nameplate in order to uniformly bond the item to the body surface. Use a roller in order to obtain proper wet-out.