Removal Procedure
- Open and support the hood at the front.
- Remove the hood support rods. Refer to Hood Open Assist Rod Replacement .
- Remove the fasteners that secure the hinge (2) to the motor compartment (3).
- Remove the fasteners that secure the hinge (2) to the hood (1).
- Remove the hinge (2).
Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
Notice: When removing body panels, apply tape to corners of panel and adjacent surfaces to help prevent paint damage.
Installation Procedure
- Position the hinge (2) to the hood (1).
- Install the fasteners bolts that secure the hinge (2) to the hood (1).
- Install the 2 fastners that secure the hinge (2) to the motor compartment (3).
- Install the hood support rods. Refer to Hood Open Assist Rod Replacement
- Remove the hood corner protection and clean away any residue.
- Close the hood and inspect for fit.
- Adjust the hood as necessary. Refer to [ADD LINK].
- Touch up any exposed or unpainted surface after you replace the hood, using body color paint [ADD LINK-SPO LABEL].
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the retainer bolts to 9 N·m (80 lb. in.).
Tighten
Tighten the retainer screws to 24 N·m (18 lb ft).
