Removal Procedure
Caution: Do not attempt to remove or loosen gas support assembly attachments
with glass in any position other than fully open as personal injury may result.
Caution: Do not try to change the designed seat position by changing the seat
adjuster-to-floor pan anchor placement or the seat adjuster-to-seat frame
anchor placement. Changing the designed seat position could affect the safe
performance of the seat and cause personal injury.
- Remove the window defogger wires attached to the gas supports (2), if equipped.
- [FROM THIS POINT ON, THE PROCEDURE IS VEHICLE SPECIFIC] Remove
the ball sockets (4) from the glass side.
| • | Support the rear window glass. |
| • | Carefully pry the gas support ball socket from the ball. |
| • | Insert a small prying device between the ball and the ball socket. |
| • | Pull the gas support from the window. |
- Remove the ball sockets (3) from the body side.
Installation Procedure
- Install the gas support
studs studs (3, 4) to the body and the glass sides. [ADD SPECIFICATIONS]
- Push the ball socket onto the ball stud.
- Install the rear window defogger wires to the gas supports (2),
if equipped.
